Shutter Door Bottom Beam Roll Former

SPECIFICATION:

• Suitable material            Carbon Steel
• Material Thickness           9~1.6mm
• Profile size90x50mm
• Complete line working speed   1~20m/min

PRODUCTION FLOW

• Steel Coil –> Hydraulic Punching –> Roll Forming Machine –> Hydraulic Cut Off –> Run Out Table –> Finished Shutter Door  Bottom Beam

DECOILER

• Coils outer diameters        1400mm
• Coils inner diameters        460-520mm
• Coils width                500mm
• Coils weight               3000kgs
• Manual way to tighten the coils

MAIN ROLL FORMER MACHINE

• Rollersstation            26 groups
• Roller material            Gr15
• Roller heat treatment       HRC55-57°
• Roller’s surface finishing poilish treatmentand chrome plate.
• Roller main shaft diameter  55mm , material : 45# steel
• Transmitt way             gear and chain
• Wall plate thickness        25mm
• Bearing                  60309
• Motor and speed reducer   5KW x2sets, speed reducer x 2 sets
• Equiped with water cooling system.

HYDRAULIC CUT OFF

• Hydraulic station             1 set
• Hydraulic station motor        4 kw
• Cut offmould                1 set  ( with the material waste way )
• Cutting mould material         Gr12MOVsteel
• Treatment hardness            HRC57°-59°
• The machine stop , then cut

RUN OUT OF TABLE

• Length                     6 meters
• welding byangle steel
• Pneumetic discharge

CONTROL SYSTEMS

• Equiped PLC and touchable screen, transducer to control the complete shutter door bottom beam roll former machine mill.
• Electric parts : Main electric parts are  good quality brand.